Embedded Files
Connecting to an ESP32 or Arduino
Connecting to an ESP32 or Arduino
Connecting to an ESP32 or Arduino
Plug in the ESP32
Plug in the ESP32
Take a usb-c cord and plug one end into the ESP32, and the other end into your computer
Open the Arduino IDE
Open the Arduino IDE
if you have no done so yet, install the Arduino IDE using the appropriate installer from the official website
Once installed open the IDE, a new sketch will automatically open
Open the Board Selection Menu
Open the Board Selection Menu
Open the Board Selection Menu, in the top left, which is shown in the photo
Click "Select Other Board And Port"
Click "Select Other Board And Port"
This opens the full menu
Find the Board and Port
Find the Board and Port
In the boards section search and select "ESP32C3 Dev Module"
In the ports section select the ESP32, this is normally on a USB, so look for a name which says "Serial Port (USB)"
Page updated
Google Sites
Report abuse